Start with the thermostat
Both Trane and Carrier start here, because the furnace only runs when the thermostat asks for heat. Make sure the screen has power and the mode is set to Heat, not Off or Cool. Set the target temperature a few degrees above the current room temperature so the furnace has a reason to start.
If the thermostat uses batteries, replace them. A dim or blank screen is the usual sign. If it is wired and the screen is blank, a loose wire or a power problem at the furnace is more likely, which leads to the next check.
Check the power to the furnace
A gas furnace still needs electricity for the control board, the inducer fan and the blower. Look for a switch on or near the furnace that looks like a light switch and make sure it is on. Then check the electrical panel for a tripped breaker labelled furnace or heat.
- Find the furnace power switch and confirm it is in the On position.
- Open the electrical panel and look for a breaker sitting in the middle or Off position.
- Reset a tripped breaker once by switching it fully off and then on.
- If the breaker trips again, leave it off and call a technician. A repeat trip means a fault that needs diagnosis.
- Make sure the furnace blower door or panel is seated properly, since many furnaces have a door switch that cuts power when the panel is loose.
Look at the filter and the vents
Carrier and Trane both note that a clogged filter can make a furnace overheat and shut itself down on a safety switch. Turn the furnace off at its switch before you open the filter slot. If the filter is grey and matted, replace it with the same size and rating. Then walk through the house and confirm supply registers and return grilles are open and not blocked by furniture, rugs or drapes.
Gas supply and ignition
If the thermostat, power and filter are fine and the furnace still will not start, the next suspects are the gas supply and the ignition system. Trane notes that the gas valve near the furnace should be in the on position, and that newer furnaces have sensors and limit switches that prevent operation when they detect a safety problem. Beyond looking at the valve handle, this is technician territory. Gas work and ignition parts are not a homeowner job. See furnace not igniting for what the ignition sequence looks like.
What you can tell a technician
- Whether anything happens at all: no sound, a fan only, a click, or a glow.
- Whether a light on the control board is flashing. Many furnaces show a code through a small window or behind the panel.
- When it stopped working, for example during a cold snap, after snow, or after a power outage.
- The furnace brand and model number, usually on a label inside the door.
- What you already checked: thermostat, switch, breaker and filter.
Cold weather and high-efficiency furnaces
In Edmonton winters, a high-efficiency furnace can refuse to start because its white plastic intake or exhaust pipe on the outside wall is blocked by snow or frost. The furnace has a pressure switch that confirms air is flowing before it lights, and it stays off if that airflow is blocked. If the furnace tries to start and then stops, read furnace frozen exhaust pipe. If it runs but only blows cool air, see furnace blowing cold air.
When to stop and call
Stop after the checks above. Trane warns that attempting to repair a gas furnace yourself can have serious safety consequences, including gas leaks. Do not bypass safety switches, open sealed panels or jump any wiring. For typical diagnostic and repair costs, see furnace repair cost in Edmonton, or request a price through the quote form.
Want numbers? Try the cost calculator or the repair-or-replace tool.